Materials for cargo tanks for a design temperature not colder than 0 °C (32 °F) must meet the following:
(b)
Plates, forgings, rolled and forged bars and shapes must be carbon manganese steel or other material allowed under §§
154.615,
154.620, and
154.625.
(c)
Plates must be normalized or quenched and tempered and where the thickness exceeds 20 mm (0.787 in.), made with fine grain practice, austenitic grain size of five or finer. A control rolling procedure may be substituted for normalizing if specially approved by the Commandant (CG-ENG). Plate for an independent tank type C must also meet the requirements of ASTM A 20 (incorporated by reference, see
§ 154.1) and
§ 54.01-18(b)(5) of this chapter.
(d)
For integral and independent type A tanks, the American Bureau of Shipping's grade D not exceeding 20 mm (0.787 in.) in thickness, and Grade E hull structural steel are allowed if the steel meets
§ 54.05-10 of this chapter.
(e)
The tensile properties under
paragraph (a) of this section must be determined for:
(1)
Each plate as rolled; and
(2)
Each five short ton batch of forgings, forged or rolled fittings, and forged or rolled bars and shapes.
(f)
The specified yield strength must not exceed 637 MPa (92.43 Ksi) and when it exceeds 490 MPa (71.10 Ksi), the hardness of the weld and the heat affected zone must be specially approved by the Commandant (CG-ENG).
(g)
The Charpy V-notch impact energy must be determined for:
(1)
Each plate as rolled; and
(2)
Each five short ton batch of forgings, forged or rolled fittings and rolled or forged bars and shapes.
(h)
The orientation and required impact energy of a 10 mm × 10 mm (0.394 in. × 0.394 in.) Charpy V-notch specimen must be:
(1)
For plates; transverse specimen and 27.4 J (20 ft-lbs); and
(2)
For forgings, forged and rolled fittings and rolled and forged bars— longitudinal specimen and 41.1 J (30 ft-lbs).
(i)
The test temperature of the Charpy V-notch specimens is as follows—
Notes, amendments, and revision history
Amendments
[CGD 74-289, 44 FR 26009, May 3, 1979, as amended by CGD 82-063b, 48 FR 4782, Feb. 3, 1983; USCG-1999-5151, 64 FR 67183, Dec. 1, 1999]
Authority
Authority: 46 U.S.C. 3703, 9101; Department of Homeland Security Delegation No. 0170.1.
Source
Source: CGD 74-289, 44 FR 26009, May 3, 1979, unless otherwise noted.
Amendments
[CGD 74-289, 44 FR 26009, May 3, 1979, as amended by CGD 82-063b, 48 FR 4782, Feb. 3, 1983; USCG-1999-5151, 64 FR 67183, Dec. 1, 1999]