§299.447. Movement of defective equipment. — Inbound Citations

(vii) The railroad shall establish a maximum safe operating speed to address brake failures that occur in revenue service as required by § 299.409(f)(4). In the event of any friction brake failure on a trainset, the speed shall be limited by ATC on-board equipment in accordance with the brake failure switch position selected by the driver and as required by § 299.447.

(3) Operating restrictions for a trainset with wheel slide protection devices that are not functioning as intended shall be defined by the railroad under its requirements for movement of defective equipment required by § 299.447, and within the railroad's operating rules, as appropriate.

(d) A trainset on which the event recorder has been taken out of service may remain in-service only until the next pre-service inspection. A trainset with an inoperative event recorder is not deemed to be in improper condition, unsafe to operate, or a non-complying trainset under § 299.447.

(5) A trainset with an inoperative image recording device alone is not deemed to be in an improper condition, unsafe to operate, or non-complying under § 299.447. However, a trainset with an entire image record system taken out of service or image recording devices taken out service in both cab ends, may not be used in revenue service beyond the next pre-service inspection required under the railroad's inspection, testing, and maintenance program without repair or replacement of the non-operative system or devices.

(1) Is being handled in accordance with § 299.447, as applicable;