§238.5. Definitions. — Inbound Citations

(1) Vehicle types permitted by FRA to operate at cant deficiencies, Eu, greater than 3 inches but not more than 5 inches shall be considered qualified under this section to operate at those permitted cant deficiencies for any Class 6 track segment. The track owner or railroad shall notify FRA in writing no less than 30 calendar days prior to the proposed implementation of such curving speeds in accordance with paragraph (f) of this section.

(1) Vehicle means a locomotive, as defined in § 229.5 of this chapter; a freight car, as defined in § 215.5 of this chapter; a passenger car, as defined in § 238.5 of this chapter; and any rail rolling equipment used in a train with either a freight car or a passenger car.

In addition to the requirements contained in this part, requirements for emergency window exits and window safety glazing on passenger equipment, as defined in § 238.5 of this chapter, are also found in part 238 of this chapter.

(i) A railroad may remove from service an image recording device on a locomotive in commuter or intercity passenger service, and must remove the device from service if the railroad knows the device is not properly recording. When a railroad removes a locomotive image recording device from service, a qualified person shall record the date the device was removed from service on Form FRA F 6180-49AP, under the REMARKS section. Except as provided in this paragraph, a locomotive on which an image recording device has been taken out of service as provided in this paragraph may remain as the lead locomotive only until the next calendar-day inspection required under § 229.21. A locomotive with an inoperative image recording device alone is not deemed to be in an improper condition, unsafe to operate, or a non-complying locomotive under §§ 229.7 and 229.9. A locomotive in a long-distance intercity passenger train, as defined in § 238.5 of this chapter, with a non-operational image recording device may remain as the lead locomotive until arrival at its destination terminal or its nearest forward point of repair, whichever occurs first.

(6) On or after November 8, 1999, paragraph (a)(1) of this section does not apply to “passenger equipment” as defined in § 238.5 of this chapter, unless such equipment is excluded from the requirements of §§ 238.203 through 238.219, and § 238.223 of this chapter by operation of § 238.201(a)(2) of this chapter. Paragraphs (a)(2) through (a)(4) of this section do not apply to “passenger equipment” as defined in § 238.5 of this chapter that is placed in service for the first time on or after September 8, 2000, unless such equipment is excluded from the requirements of §§ 238.203 through 238.219, and § 238.223 of this chapter by operation of § 238.201(a)(2) of this chapter.

(c) Paragraphs (a) and (b) of § 229.125 do not apply to Tier II passenger equipment as defined in § 238.5 of this chapter (i.e., passenger equipment operating at speeds exceeding 125 mph but not exceeding 160 mph).

(c) Except for the provisions governing uncoupling devices, this part does not apply to Tier II passenger equipment as defined in § 238.5 of this chapter (i.e., passenger equipment operating at speeds exceeding 125 mph but not exceeding 160 mph).

(a) Any person, as defined in § 238.5, who violates any requirement of this part or causes the violation of any such requirement is subject to a civil penalty of at least the minimum civil monetary penalty and not more than the ordinary maximum civil monetary penalty per violation. However, penalties may be assessed against individuals only for willful violations, and a penalty not to exceed the aggravated maximum civil monetary penalty per violation may be assessed, where a grossly negligent violation, or a pattern of repeated violations, has created an imminent hazard of death or injury to persons, or a death or injury has occurred. See 49 CFR part 209, appendix A. Each day a violation continues shall constitute a separate offense. See FRA's website at https://railroads.dot.gov/ for a statement of agency civil penalty policy.

(1) Equipped with piston travel indicators as defined in § 238.5 or devices of similar design and inspected pursuant to the requirements contained in § 238.313 (j); or

(c) Although the duties imposed by this part are generally stated in terms of the duty of a railroad, any person as defined in § 238.5, including a contractor for a railroad, who performs any function covered by this part must perform that function in accordance with this part.

(2) If a railroad does not have designated employee representation, then a person employed by the railroad need not comply with paragraph (1)(ii) or (iii) of this definition to be an instructor engineer.

Joint Operations means rail operations conducted by more than one railroad on the same track regardless of whether such operations are the result of—

(2) Order of a governmental agency or a court of law, or

As used in this chapter: