§73.310. FM technical definitions. — Inbound Citations

(2) For purposes of this section, the term FM station means an “FM broadcast station” as defined in § 73.310.

(a) All noncommercial educational stations and LPFM stations operating with more than 10 watts transmitter power output shall be subject to all of the provisions of the FM Technical Standards contained in subpart B of this part. Class D educational stations and LPFM stations operating with 10 watts or less transmitter output power shall be subject to the definitions contained in § 73.310, and also to those other provisions of the FM Technical Standards which are specifically made applicable to them by the provisions of this subpart.

(v) Section 73.310, FM technical definitions.

(ii) Level 1 rates as set forth in paragraph (c)(1)(i) of this section, shall also apply to College Radio Stations with an authorized ERP, as that term is defined in 47 CFR 73.310(a), of 100 Watts or less, as specified on its current Federal Communications Commission (FCC) license, regardless of the size of the student population.

(i) The antenna height above terrain (defined in § 73.310(a)) is computed as follows:

(a) The following definitions pertain to frequency modulation, as defined in § 73.310(a)(17).

(1) HAAT is calculated by: determining the average of the antenna heights above the terrain from 3 to 16 kilometers (2 to 10 miles) from the antenna for the eight directions evenly spaced for each 45° of azimuth starting with True North (a different antenna height will be determined in each direction from the antenna): and computing the average of these separate heights. In some cases less than eight directions may be used. (See § 73.313(d).) Where circular or elliptical polarization is used, the antenna height above average terrain must be based upon the height of the radiation of the antenna that transmits the horizontal component of radiation.

(2) The square of the ratio of the root-mean-square (RMS) free space field strength produced at 1 kilometer in the horizontal plane in millivolts per meter for 1 kW antenna input power to 221.4 mV/m. This ratio is expressed in decibels (dB). If specified for a particular direction, antenna power gain is based on that field strength in the direction only.

(3) An auxiliary facility is an antenna separate from the main facility's antenna, permanently installed on the same tower or at a different location, from which a station may broadcast for short periods without prior Commission authorization or notice to the Commission while the main facility is not in operation (e.g., where tower work necessitates turning off the main antenna or where lightning has caused damage to the main antenna or transmission system) (See § 73.1675).

(4) The term “center frequency” means:

(5) The composite antenna pattern is a relative field horizontal plane pattern for 360 degrees of azimuth, for which the value at a particular azimuth is the greater of the horizontally polarized or vertically polarized component relative field values. The composite antenna pattern is normalized to a maximum of unity (1.000) relative field.

(6) A signal which is composed of all program and other communications signals that frequency modulates the FM carrier.

(7) The term “effective radiated power” means the product of the antenna power (transmitter output power less transmission line loss) times:

(i) The antenna power gain, or

(ii) the antenna field gain squared. Where circular or elliptical polarization is employed, the term effective radiated power is applied separately to the horizontal and vertical components of radiation. For allocation purposes, the effective radiated power authorized is the horizontally polarized component of radiation only.

(8) The term “equivalent isotropically radiated power (also known as “effective radiated power above isotropic) means the product of the antenna input power and the antenna gain in a given direction relative to an isotropic antenna.

(9) Blanketing is that form of interference to the reception of other broadcast stations which is caused by the presence of an FM broadcast signal of 115 dBµ (562 mV/m) or greater signal strength in the area adjacent to the antenna of the transmitting station. The 115 dBµ contour is referred to as the blanketing contour and the area within this contour is referred to as the blanketing area.

(10) The band of frequencies extending from 88 to 108 MHz, which includes those assigned to noncommercial educational broadcasting.

(11) A band of frequencies 200 kHz wide and designated by its center frequency. Channels for FM broadcast stations begin at 88.1 MHz and continue in successive steps of 200 kHz to and including 107.9 MHz.

(12) A station employing frequency modulation in the FM broadcast band and licensed primarily for the transmission of radiotelephone emissions intended to be received by the general public.

(13) The electric field strength in the horizontal plane.

(14) The field strength that would exist at a point in the absence of waves reflected from the earth or other reflecting objects.

(15) The amount of variation of a carrier frequency or center frequency from its assigned value.

(16) The peak difference between modulated wave and the carrier frequency.

(17) A system of modulation where the instantaneous radio frequency varies in proportion to the instantaneous amplitude of the modulating signal (amplitude of modulating signal to be measured after pre-emphasis, if used) and the instantaneous radio frequency is independent of the frequency of the modulating signal.

(18) The peak difference between the maximum and the minimum values of the instantaneous frequency of the carrier wave during modulation.

(19) The term “multiplex transmission” means the simultaneous transmission of two or more signals within a single channel. Multiplex transmission as applied to FM broadcast stations means the transmission of facsimile or other signals in addition to the regular broadcast signals.

(20) The ratio of the actual frequency deviation to the frequency deviation defined as 100% modulation, expressed in percentage. For FM broadcast stations, a frequency deviation of ±75kHz is defined as 100% modulation.

(b) The following definitions pertain to stereophonic sound broadcasting, as defined in § 73.310(b)(8).

(1) An undesired signal occurring in one channel caused by an electrical signal in another channel.

(2) The transmission of a stereophonic program by a single FM broadcast station utilizing the main channel and a stereophonic subchannel.

(3) The electrical output of a microphone or combination of microphones placed so as to convey the intensity, time, and location of sounds originating predominately to the listener's left (or right) of the center of the performing area.

(4) The left (or right) signal as electrically reproduced in reception of FM stereophonic broadcasts.

(5) The band of frequencies from 50 to 15,000 Hz which frequency-modulate the main carrier.

(6) A subcarrier that serves as a control signal for use in the reception of FM stereophonic sound broadcasts.

(7) The ratio of the electrical signal caused in sound channel A to the signal caused in sound channel B by the transmission of only a channel B signal. Channels A and B may be any two channels of a stereophonic sound broadcast transmission system.

(8) The audio information carried by plurality of channels arranged to afford the listener a sense of the spatial distribution of sound sources. Stereophonic sound broadcasting includes, but is not limited to, biphonic (two channel), triphonic (three channel) and quadrophonic (four channel) program services.

(9) A subcarrier within the FM broadcast baseband used for transmitting signals for stereophonic sound reception of the main broadcast program service.

(10) The band of frequencies from 23 kHz to 99 kHz containing sound subcarriers and their associated sidebands.