US Codex
C.F.R.
Browse by date
Notes

§62.14442. What must my inspection include?

40 C.F.R. § 62.14442

(a)
At a minimum, you must do the following during your HMIWI equipment inspection:
(1)
Inspect all burners, pilot assemblies, and pilot sensing devices for proper operation, and clean pilot flame sensor as necessary;
(2)
Check for proper adjustment of primary and secondary chamber combustion air, and adjust as necessary;
(3)
Inspect hinges and door latches, and lubricate as necessary;
(4)
Inspect dampers, fans, and blowers for proper operation;
(5)
Inspect HMIWI door and door gaskets for proper sealing;
(6)
Inspect motors for proper operation;
(7)
Inspect primary chamber refractory lining, and clean and repair/replace lining as necessary;
(8)
Inspect incinerator shell for corrosion and/or hot spots;
(9)
Inspect secondary/tertiary chamber and stack, and clean as necessary;
(10)
Inspect mechanical loader, including limit switches, for proper operation, if applicable;
(11)
Visually inspect waste bed (grates), and repair/ seal, as necessary;
(12)
For the burn cycle that follows the inspection, document that the incinerator is operating properly and make any necessary adjustments;
(13)
Inspect air pollution control device(s) for proper operation, if applicable;
(14)
Inspect waste heat boiler systems to ensure proper operation, if applicable;
(15)
Inspect bypass stack components;
(16)
Ensure proper calibration of thermocouples, sorbent feed systems and any other monitoring equipment; and
(17)
Include inspection elements according to manufacturer's recommendations; and
(18)
Generally observe that the equipment is maintained in good operating condition.
(b)
At a minimum, you must do the following during your air pollution control device inspection:
(1)
Inspect air pollution control device(s) for proper operation, if applicable;
(2)
Ensure proper calibration of thermocouples, sorbent feed systems and any other monitoring equipment; and
(3)
Include inspection elements according to manufacturer's recommendations; and
(4)
Generally observe that the equipment is maintained in good operating condition.
Notes, amendments, and revision history

Amendments

[65 FR 49881, Aug. 15, 2000, as amended at 78 FR 28068, May 13, 2013]

Source

Source: 65 FR 49881, Aug. 15, 2000, unless otherwise noted.

Authority

Authority: 42 U.S.C. 7401 et seq.

Source

Source: 43 FR 51393, Nov. 3, 1978, unless otherwise noted.

Amendments

[65 FR 49881, Aug. 15, 2000, as amended at 78 FR 28068, May 13, 2013]