§154.500. Hose assemblies. — Inbound Citations

(10) Section 154.500 Hose assemblies. Paragraphs (a), (b), (c), (d)(1) through (3) and (e)(1) through (3).

Hose used to transfer oil or hazardous material must meet the requirements of § 154.500 of this chapter.

(j) Each hose or loading arm in use meets §§ 154.500 and 154.510 of this chapter, respectively;

(i) The hose complies with 33 CFR 154.500 or the portable piping complies with part 56 of this chapter;

(a) Larger than three inches, must meet the requirements in 33 CFR 154.500; or

(1) ANSI B16.5, Steel Pipe Flanges and Flanged Fittings, 1988, IBR approved for §§ 154.500(d), 154.2100(b), 154.2101(d), 154.2202(d), and Appendix A, 7.3 to part 154.

(2) Use a bolt in at least every other hole, and in no case less than four bolts, in each temporary bolted connection that uses a flange that meets American National Standards Institute (ANSI) standard flange requirements under § 154.500(d)(2) of this chapter;

(d) The hose information required by § 154.500 (e) and (g) except that marked on the hose;

(c) The hose information required by § 154.500(e) and (g) of this chapter unless that information is marked on the hose; and

(d) The hose information required by § 154.500 (e) and (g) except that marked on the hose;

(c) The hose information required by § 154.500(e) and (g) of this chapter unless that information is marked on the hose; and