§778.415. The statutory provisions. — Inbound Citations

The regulations for computing overtime pay under sections 7(g)(1) and 7(g)(2) of the Fair Labor Standards Act of 1938, as amended (“the Act” or “FLSA”), for employees paid on the basis of a piece rate, or at a variety of hourly rates or piece rates, or a combination thereof, are set forth in §§ 778.415 through 778.421. Payment of overtime compensation in accordance with other subsections of section 7 of the Act is explained in part 778 of this title (Interpretive Bulletin on Overtime Compensation).

The general overtime pay standard in section 7(a) requires that overtime must be compensated at a rate not less than one and one-half times the regular rate at which the employee is actually employed. The regular rate of pay at which the employee is employed may in no event be less than the statutory minimum. (The statutory minimum is the specified minimum wage applicable under section 6 of the Act, except in the case of workers specially provided for in section 14 and workers in Puerto Rico, the Virgin Islands, and American Samoa who are covered by wage orders issued pursuant to section 8 of the Act.) If the employee's regular rate of pay is higher than the statutory minimum, his overtime compensation must be computed at a rate not less than one and one-half times such higher rate. Under certain conditions prescribed in section 7 (f), (g), and (j), the Act provides limited exceptions to the application of the general standard of section 7(a) for computing overtime pay based on the regular rate. With respect to these, see §§ 778.400 through 778.421 and 778.601 and part 548 of this chapter. The Act also provides, in section 7(b), (i), (k) and (m) and in section 13, certain partial and total exemptions from the application of section 7(a) to certain employees and under certain conditions. Regulations and interpretations concerning these exemptions are outside the scope of this part 778 and reference should be made to other applicable parts of this chapter.

The “regular rate” under the Act is a rate per hour. The Act does not require employers to compensate employees on an hourly rate basis; their earnings may be determined on a piece-rate, salary, commission, or other basis, but in such case the overtime compensation due to employees must be computed on the basis of the hourly rate derived therefrom and, therefore, it is necessary to compute the regular hourly rate of such employees during each workweek, with certain statutory exceptions discussed in §§ 778.400 through 778.421. The regular hourly rate of pay of an employee is determined by dividing his total remuneration for employment (except statutory exclusions) in any workweek by the total number of hours actually worked by him in that workweek for which such compensation was paid. The following sections give some examples of the proper method of determining the regular rate of pay in particular instances: (The maximum hours standard used in these examples is 40 hours in a workweek).

Where an employee in a single workweek works at two or more different types of work for which different nonovertime rates of pay (of not less than the applicable minimum wage) have been established, his regular rate for that week is the weighted average of such rates. That is, his total earnings (except statutory exclusions) are computed to include his compensation during the workweek from all such rates, and are then divided by the total number of hours worked at all jobs. Certain statutory exceptions permitting alternative methods of computing overtime pay in such cases are discussed in §§ 778.400 and 778.415 through 778.421.

(a) “Special days” rate must be at least time and one-half to qualify as overtime premium: The premium rate must be at least “one and one-half times the rate established in good faith for like work performed in nonovertime hours on other days.” Where an employee is hired on the basis of a salary for a fixed workweek or at a single hourly rate of pay, the rate paid for work on “special days” must be at least time and one-half his regular hourly rate in order to qualify under section 7(e)(6). If the employee is a pieceworker or if he works at more than one job for which different hourly or piece rates have been established and these are bona fide rates applicable to the work when performed during nonovertime hours, the extra compensation provided by a premium rate of at least one and one-half times either (1) the bona fide rate applicable to the type of job the employee performs on the “special days”, or (2) the average hourly earnings in the week in question, will qualify as an overtime premium under this section. (For a fuller discussion of computation on the average rate, see § 778.111; on the rate applicable to the job, see §§ 778.415 through 778.421; on the “established” rate, see § 778.400.)

(a) Section 7(a) of the Act requires the payment of overtime compensation for hours worked in excess of the applicable maximum hours standard at a rate not less than one and one-half times the regular rate. The overtime rate, like the regular rate, is a rate per hour. Where employees are paid on some basis other than an hourly rate, the regular hourly rate is derived, as previously explained, by dividing the total compensation (except statutory exclusions) by the total hours of work for which the payment is made. To qualify as an overtime premium under section 7(e)(5), (6), or (7), the extra compensation for overtime hours must be paid pursuant to a premium rate which is likewise a rate per hour (subject to certain statutory exceptions discussed in §§ 778.400 through 778.421).

(a) The same reasoning applies where employees are paid a flat rate for a special job performed during overtime hours, without regard to the time actually consumed in performance. (This situation should be distinguished from “show-up” and “call-back” pay situations discussed in §§ 778.220 through 778.222 and from payment at a rate not less than one and one-half times the applicable rate to pieceworkers for work performed during overtime hours, as discussed in §§ 778.415 through 778.421). The total amount paid must be included in the regular rate; no part of the amount may be credited toward statutory overtime compensation due.

There may be special situations in which the facts demonstrate that the hours for which contract overtime compensation is paid to employees working on a “task” or “stint” basis actually qualify as overtime hours under section 7(e)(5), (6), or (7). Where this is true, payment of one and one-half times an agreed hourly rate for “task” or “stint” work may be equivalent to payment pursuant to agreement of one and one-half time a piece rate. The alternative methods of overtime pay computation permitted by section 7(g)(1) or (2), as explained in §§ 778.415 through 778.421 may be applicable in such a case.

(b) The parties may agree to compensate nonproductive hours worked at a rate (at least the minimum) which is lower than the rate applicable to productive work. In such a case, the regular rate is the weighted average of the two rates, as discussed in § 778.115 and the employee whose maximum hours standard is 40 hours is owed compensation at his regular rate for all of the first 40 hours and at a rate not less than one and one-half times this rate for all hours in excess of 40. (See § 778.415 for the alternative method of computing overtime pay on the applicable rate.) In the absence of any agreement setting a different rate for nonproductive hours, the employee would be owed compensation at the regular hourly rate set for productive work for all hours up to 40 and at a rate at least one and one-half times that rate for hours in excess of 40.

The purpose of the provisions set forth in § 778.415 is to provide an exception from the requirement of computing overtime pay at not less than one and one-half times the regular rate for hours worked in excess of the applicable maximum hours standard for a particular workweek and to allow, under specified conditions, a simpler method of computing overtime pay for employees paid on the basis of a piece rate, or at a variety of hourly rates or piece rates, or a combination thereof. This provision is not designed to exclude any group of employees from the overtime benefits of the Act. The intent of the provision is merely to simplify the method of computation while insuring the receipt by the affected employees of substantially the same amount of overtime compensation.