§985.3. Indicators, HUD verification methods and ratings. — Inbound Citations

(c) Subpart D of this part covers the HCV and PBV assessment for a small rural PHA as defined in § 902.101 of this chapter. Section 985.3 and subparts B and C of this part do not apply to small rural PHAs.

Upon receipt of the PHA's SEMAP certification, HUD will rate the PHA's performance under each SEMAP indicator in accordance with § 985.3. HUD will then prepare a SEMAP profile for each PHA which shows the rating for each indicator, sums the indicator ratings, and divides by the total possible points to arrive at an PHA's overall SEMAP score. SEMAP scores shall be rounded off to the nearest whole percent.

(b) The definitions in 24 CFR 982.4 apply to this part. As used in this part:

Confirmatory review means an on site review performed by HUD to verify the management performance of an PHA.

Corrective action plan means a HUD-required written plan that addresses PHA program management deficiencies or findings identified by HUD through remote monitoring or on-site review, and that will bring the PHA to an acceptable level of performance.

MTCS means Multifamily Tenant Characteristics System. MTCS is the Department's national database on participants and rental units in the Section 8 rental certificate, rental voucher, and moderate rehabilitation programs and in the Public and Indian Housing programs.

PHA means a Housing Agency.

PHA's quality control sample means an annual sample of files or records drawn in an unbiased manner and reviewed by an PHA supervisor (or by another qualified person other than the person who performed the original work) to determine if the work documented in the files or records conforms to program requirements. The minimum size of the PHA's quality control sample is as follows:

Performance indicator means a standard set for a key area of Section 8 program management against which the PHA's performance is measured to show whether the PHA administers the program properly and effectively. (See § 985.3.)

SEMAP certification means the PHA's annual certification to HUD, on the form prescribed by HUD, concerning its performance in key Section 8 program areas.

SEMAP deficiency means any rating of 0 points on a SEMAP performance indicator.

SEMAP profile means a summary prepared by HUD of an PHA's ratings on each SEMAP indicator, its overall SEMAP score, and its overall performance rating (high performer, standard, troubled).

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.

This section states the performance indicators that are used to assess PHA Section 8 management. HUD will use the verification method identified for each indicator in reviewing the accuracy of an PHA's annual SEMAP certification. HUD will prepare a SEMAP profile for each PHA and will assign a rating for each indicator as shown. If the HUD verification method for the indicator relies on data in MTCS and HUD determines those data are insufficient to verify the PHA's certification on the indicator due to the PHA's failure to adequately report family data, HUD will assign a zero rating for the indicator. The method for selecting the PHA's quality control sample under paragraphs (a), (b), (c) and (f) of this section must leave a clear audit trail that can be used to verify that the PHA's quality control sample was drawn in an unbiased manner.

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.

This section states the performance indicators that are used to assess PHA Section 8 management. HUD will use the verification method identified for each indicator in reviewing the accuracy of an PHA's annual SEMAP certification. HUD will prepare a SEMAP profile for each PHA and will assign a rating for each indicator as shown. If the HUD verification method for the indicator relies on data in MTCS and HUD determines those data are insufficient to verify the PHA's certification on the indicator due to the PHA's failure to adequately report family data, HUD will assign a zero rating for the indicator. The method for selecting the PHA's quality control sample under paragraphs (a), (b), (c) and (f) of this section must leave a clear audit trail that can be used to verify that the PHA's quality control sample was drawn in an unbiased manner.

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.

This section states the performance indicators that are used to assess PHA Section 8 management. HUD will use the verification method identified for each indicator in reviewing the accuracy of an PHA's annual SEMAP certification. HUD will prepare a SEMAP profile for each PHA and will assign a rating for each indicator as shown. If the HUD verification method for the indicator relies on data in MTCS and HUD determines those data are insufficient to verify the PHA's certification on the indicator due to the PHA's failure to adequately report family data, HUD will assign a zero rating for the indicator. The method for selecting the PHA's quality control sample under paragraphs (a), (b), (c) and (f) of this section must leave a clear audit trail that can be used to verify that the PHA's quality control sample was drawn in an unbiased manner.

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.

This section states the performance indicators that are used to assess PHA Section 8 management. HUD will use the verification method identified for each indicator in reviewing the accuracy of an PHA's annual SEMAP certification. HUD will prepare a SEMAP profile for each PHA and will assign a rating for each indicator as shown. If the HUD verification method for the indicator relies on data in MTCS and HUD determines those data are insufficient to verify the PHA's certification on the indicator due to the PHA's failure to adequately report family data, HUD will assign a zero rating for the indicator. The method for selecting the PHA's quality control sample under paragraphs (a), (b), (c) and (f) of this section must leave a clear audit trail that can be used to verify that the PHA's quality control sample was drawn in an unbiased manner.

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.

This section states the performance indicators that are used to assess PHA Section 8 management. HUD will use the verification method identified for each indicator in reviewing the accuracy of an PHA's annual SEMAP certification. HUD will prepare a SEMAP profile for each PHA and will assign a rating for each indicator as shown. If the HUD verification method for the indicator relies on data in MTCS and HUD determines those data are insufficient to verify the PHA's certification on the indicator due to the PHA's failure to adequately report family data, HUD will assign a zero rating for the indicator. The method for selecting the PHA's quality control sample under paragraphs (a), (b), (c) and (f) of this section must leave a clear audit trail that can be used to verify that the PHA's quality control sample was drawn in an unbiased manner.

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.

This section states the performance indicators that are used to assess PHA Section 8 management. HUD will use the verification method identified for each indicator in reviewing the accuracy of an PHA's annual SEMAP certification. HUD will prepare a SEMAP profile for each PHA and will assign a rating for each indicator as shown. If the HUD verification method for the indicator relies on data in MTCS and HUD determines those data are insufficient to verify the PHA's certification on the indicator due to the PHA's failure to adequately report family data, HUD will assign a zero rating for the indicator. The method for selecting the PHA's quality control sample under paragraphs (a), (b), (c) and (f) of this section must leave a clear audit trail that can be used to verify that the PHA's quality control sample was drawn in an unbiased manner.

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.

This section states the performance indicators that are used to assess PHA Section 8 management. HUD will use the verification method identified for each indicator in reviewing the accuracy of an PHA's annual SEMAP certification. HUD will prepare a SEMAP profile for each PHA and will assign a rating for each indicator as shown. If the HUD verification method for the indicator relies on data in MTCS and HUD determines those data are insufficient to verify the PHA's certification on the indicator due to the PHA's failure to adequately report family data, HUD will assign a zero rating for the indicator. The method for selecting the PHA's quality control sample under paragraphs (a), (b), (c) and (f) of this section must leave a clear audit trail that can be used to verify that the PHA's quality control sample was drawn in an unbiased manner.

(1) Such a PHA may obtain HUD Field Office approval of a payment standard amount based on the 50th percentile rent if the PHA scored the maximum number of points on the deconcentration bonus indicator in 24 CFR 985.3(h) in the prior year, or in two of the last three years.

(d) A rating on any of the indicators at §§ 985.3(a) through 985.3(h) will be subject to change after HUD receives the PHA's annual audit report or after HUD conducts a confirmatory review if the audit report or the confirmatory review report contains information that the PHA's SEMAP certification concerning an indicator is not accurate.