§91.227. Automatic Dependent Surveillance-Broadcast (ADS-B) Out equipment performance requirements. — Inbound Citations

(2) Meets the requirements of § 91.227.

(d) Each aircraft must broadcast the following information, as defined in TSO-C166b (including Section 2 of RTCA DO-260B, as referenced in TSO-C166b), TSO-C166c (including Section 2 of RTCA DO-260C as modified by DO-260C—Change 1, as referenced in TSO-C166c), TSO-C154c (including Section 2 of RTCA DO-282B, as referenced in TSO-C154c), or TSO-C154d (including Section 2 of RTCA DO-282C, as referenced in TSO-C154d). The pilot must enter information for message elements listed in paragraphs (d)(7) through (10) of this section during the appropriate phase of flight.

(1) The length and width of the aircraft;

(2) An indication of the aircraft's latitude and longitude;

(3) An indication of the aircraft's barometric pressure altitude;

(4) An indication of the aircraft's velocity;

(5) An indication if a collision avoidance system is installed and operating in a mode that can generate resolution advisory alerts;

(6) If an operable collision avoidance system is installed, an indication if a resolution advisory is in effect;

(7) An indication of the Mode A transponder code specified by ATC;

(8) An indication of the aircraft identification that is submitted on the flight plan or used for communicating with ATC, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(9) An indication if the flightcrew has identified an emergency, radio communication failure, or unlawful interference;

(10) An indication of the aircraft's “IDENT” to ATC;

(11) An indication of the aircraft assigned ICAO 24-bit address, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(12) An indication of the aircraft's emitter category;

(13) An indication of whether an ADS-B In capability is available;

(14) An indication of the aircraft's geometric altitude;

(15) An indication of the Navigation Accuracy Category for Position (NACP);

(16) An indication of the Navigation Accuracy Category for Velocity (NACV);

(17) An indication of the Navigation Integrity Category (NIC);

(18) An indication of the System Design Assurance (SDA); and

(d) Each aircraft must broadcast the following information, as defined in TSO-C166b (including Section 2 of RTCA DO-260B, as referenced in TSO-C166b), TSO-C166c (including Section 2 of RTCA DO-260C as modified by DO-260C—Change 1, as referenced in TSO-C166c), TSO-C154c (including Section 2 of RTCA DO-282B, as referenced in TSO-C154c), or TSO-C154d (including Section 2 of RTCA DO-282C, as referenced in TSO-C154d). The pilot must enter information for message elements listed in paragraphs (d)(7) through (10) of this section during the appropriate phase of flight.

(1) The length and width of the aircraft;

(2) An indication of the aircraft's latitude and longitude;

(3) An indication of the aircraft's barometric pressure altitude;

(4) An indication of the aircraft's velocity;

(5) An indication if a collision avoidance system is installed and operating in a mode that can generate resolution advisory alerts;

(6) If an operable collision avoidance system is installed, an indication if a resolution advisory is in effect;

(7) An indication of the Mode A transponder code specified by ATC;

(8) An indication of the aircraft identification that is submitted on the flight plan or used for communicating with ATC, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(9) An indication if the flightcrew has identified an emergency, radio communication failure, or unlawful interference;

(10) An indication of the aircraft's “IDENT” to ATC;

(11) An indication of the aircraft assigned ICAO 24-bit address, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(12) An indication of the aircraft's emitter category;

(13) An indication of whether an ADS-B In capability is available;

(14) An indication of the aircraft's geometric altitude;

(15) An indication of the Navigation Accuracy Category for Position (NACP);

(16) An indication of the Navigation Accuracy Category for Velocity (NACV);

(17) An indication of the Navigation Integrity Category (NIC);

(18) An indication of the System Design Assurance (SDA); and

(d) Each aircraft must broadcast the following information, as defined in TSO-C166b (including Section 2 of RTCA DO-260B, as referenced in TSO-C166b), TSO-C166c (including Section 2 of RTCA DO-260C as modified by DO-260C—Change 1, as referenced in TSO-C166c), TSO-C154c (including Section 2 of RTCA DO-282B, as referenced in TSO-C154c), or TSO-C154d (including Section 2 of RTCA DO-282C, as referenced in TSO-C154d). The pilot must enter information for message elements listed in paragraphs (d)(7) through (10) of this section during the appropriate phase of flight.

(1) The length and width of the aircraft;

(2) An indication of the aircraft's latitude and longitude;

(3) An indication of the aircraft's barometric pressure altitude;

(4) An indication of the aircraft's velocity;

(5) An indication if a collision avoidance system is installed and operating in a mode that can generate resolution advisory alerts;

(6) If an operable collision avoidance system is installed, an indication if a resolution advisory is in effect;

(7) An indication of the Mode A transponder code specified by ATC;

(8) An indication of the aircraft identification that is submitted on the flight plan or used for communicating with ATC, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(9) An indication if the flightcrew has identified an emergency, radio communication failure, or unlawful interference;

(10) An indication of the aircraft's “IDENT” to ATC;

(11) An indication of the aircraft assigned ICAO 24-bit address, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(12) An indication of the aircraft's emitter category;

(13) An indication of whether an ADS-B In capability is available;

(14) An indication of the aircraft's geometric altitude;

(15) An indication of the Navigation Accuracy Category for Position (NACP);

(16) An indication of the Navigation Accuracy Category for Velocity (NACV);

(17) An indication of the Navigation Integrity Category (NIC);

(18) An indication of the System Design Assurance (SDA); and

(d) Each aircraft must broadcast the following information, as defined in TSO-C166b (including Section 2 of RTCA DO-260B, as referenced in TSO-C166b), TSO-C166c (including Section 2 of RTCA DO-260C as modified by DO-260C—Change 1, as referenced in TSO-C166c), TSO-C154c (including Section 2 of RTCA DO-282B, as referenced in TSO-C154c), or TSO-C154d (including Section 2 of RTCA DO-282C, as referenced in TSO-C154d). The pilot must enter information for message elements listed in paragraphs (d)(7) through (10) of this section during the appropriate phase of flight.

(1) The length and width of the aircraft;

(2) An indication of the aircraft's latitude and longitude;

(3) An indication of the aircraft's barometric pressure altitude;

(4) An indication of the aircraft's velocity;

(5) An indication if a collision avoidance system is installed and operating in a mode that can generate resolution advisory alerts;

(6) If an operable collision avoidance system is installed, an indication if a resolution advisory is in effect;

(7) An indication of the Mode A transponder code specified by ATC;

(8) An indication of the aircraft identification that is submitted on the flight plan or used for communicating with ATC, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(9) An indication if the flightcrew has identified an emergency, radio communication failure, or unlawful interference;

(10) An indication of the aircraft's “IDENT” to ATC;

(11) An indication of the aircraft assigned ICAO 24-bit address, except when the pilot has not filed a flight plan, has not requested ATC services, and is using a TSO-C154c or TSO-C154d self-assigned temporary 24-bit address;

(12) An indication of the aircraft's emitter category;

(13) An indication of whether an ADS-B In capability is available;

(14) An indication of the aircraft's geometric altitude;

(15) An indication of the Navigation Accuracy Category for Position (NACP);

(16) An indication of the Navigation Accuracy Category for Velocity (NACV);

(17) An indication of the Navigation Integrity Category (NIC);

(18) An indication of the System Design Assurance (SDA); and